Description
Scissor Lift – RLP77 | Low Profile | Double Section
Features
Synchrodrive Equalization System
The hydraulic system that maintains platform equalization during lift and lower cycles also prevent out-of-level situations in the event of an obstruction in the scissor lift. There are no electronics or sensors that can fail, and there are fewer moving parts for easier maintenance.
Ramp ends fold 65º down and away in order to provide more access for wheel and brake service.
13 inch long underhung ramps with rollers maximize rubber block footprint, increasing reliability, and protect unlevel floor installations.
The RLP77’s composite high-strength steel construction and powder-coated surface ensure a long life for your lift.
26 Lock Positions featuring our negative rake tooth design. Locks ratchet over each other then interlock when lift it lowered to those locks.
Easily access slider blocks for regular maintenance, see instruction manual for more details.
Adjustable lift dampener eliminates end of downward travel sudden impacts. Lifts not equipped with this slam into the floor causing damage to shop/lift and create an unwanted loud noise.
Stainless Steel Kicker Rollers provide long-lasting protection to critical contact points.
Kick Plate eliminates corrosion on high contact wear area.
Engagement and release of ramps are easily attainable from any angle of the lift, improving technician accessibility.
One Piece Formed Diamond Plate Platforms. Maintain Rubber Block Positioning. Increase Drive-Over Traction.
Composite High Strength Steel Scissor Legs, Patent Pending.
Scaled Up Control Console Design with Filter, Regulator, Lubricator assembly suppressed in side of cabinet, fully hinged door and top.
Filter, Regulator, Lubricator assembly suppressed inside of the cabinet.
Synchrodrive™ Equalization System, a hydraulic cylinder system that does the lifting work equally.
Pictured is the RLP77 collapsed to its 4-1/8 inch height off the floor. Outriggers on either side allow you to pull wider wheel base vehicles over the lift while still picking up the vehicle via the platform.
Specifications
| Specification | RLP77 |
| Capacity | 7,700 LBS. |
| Rise | 78-5/8″ |
| Lowered Height | 4-1/8″ |
| Overall Length | 85″ |
| Overall Width | 85″ |
| Runway Width | 24-3/4″ |
| Width Between Platforms | 23-5/8″ |
| Platform Length | 59″ |
| Motor/Voltage | Single Phase – 4 Hp, 60Hz, 230V |
| Compressed Air Connection | 85-110 psi |
| Time of Full Rise | 39 seconds |
